Subscribed unsubscribe Subscribe Subscribe

Tech and Support for OBD2

Technical Support blog about car diagnostic tools introduction, setup, update and FAQ

Nissan Consult III work with Renault CAN CLIP software?

I was wondering if a Nissan Consult III hardware works with Renault CAN CLIP. Then I went to forums to search for it.
This is the Consult III I’m talking about (Chinese clone with the pcb above)
NOTE: you will be at risk to try this.
Review from TizWoz
Yes it will work with both, it is alliance B
Do not but the ones flying around with the WHITE < <16 PIN CONNECTOR.
As regards programming, im unsure because I never tested, However there are can clip interfaces that are alliance B and they work fine.
Review from blck
If that is recognized as VI alliance by drivers this will work with Clip and Consult too
I’d say that there is very high chance of success.
Review from ABD Jeffrey
Nissan consult 3 can work with Nissan and Renault cars, while there is only nissan software come with the interface, you need to buy renault software extra
Review from pb1234
Consult-3 A
Consult-3 B
I know that there are good clones. I had one in the picture,, A,, worked perfectly with Nissan and Renault Clip.
It is risky to start with this hardware, for example, flashing the control unit of the vehicle. That’s why I at first was looking for the original hardware, or really good clone.
Ps. V152 CAN CLIP iso torrent free download:
https://www.dropbox.com/s/6z6y0jauhfntta7/Clip%20152%20multi.zip?dl=0

This article from:Nissan Consult III work with Renault Can clip software

 
And more information about renautl can clip interface,pls visit:
http://www.uobd2.net/wholesale/renault-can-clip-latest-diagnostic-tool.html